Cars Pictures and Photos

April 24, 2009

2009 Acura TSX/ First Impressions

Filed under: Acura — Tags: — admin @ 8:06 pm

2009-acura-tsx_62009 Acura TSX  ,Acura TSX

From Wikipedia, the free encyclopedia

The fully redesigned 2009 Acura TSX made its debut at the 2008 New York International Auto Show on April 11, 2008.[7] The new TSX uses a base engine similar to that of the 2008 TSX. The engine is a 2.4-litre in-line 4 cylinder engine reaching 201 hp (150 kW) and 172 lb·ft (233 N·m) torque.[8] While the rated power of the new TSX engine is 4 hp (3.0 kW) lower than that of the 2008 model, Acura says the new engine distributes power across a much wider rpm range, which along with the increased torque, provides an increased feeling of power for the driver. The transmission choices remain 5-speed automatic and 6-speed manual, though the automatic version now comes with steering-wheel paddle shifters for optional manual shifting.

2009-acura-tsx_7

2009 Acura TSX

In addition to the 2.4-litre engine, the Acura TSX also receives Honda’s 2.2-litre i-DTEC clean turbodiesel engine in the 2010 calendar year. The i-DTEC engine features an advanced NOx emissions reduction system that does not require urea additives to meet emissions standards in all 50 states.[9][10] While no official numbers on the TSX’s new diesel engine have been released, some speculation places the engine at roughly 180 hp (134 kW).[11] The i-DTEC engine to be used in the Euro Accord is rated at 148 hp (110 kW) and 258 lb·ft (350 N·m) torque,[12] but the TSX’s version has higher output.

2009-acura-tsx_4

2009 Acura TSX

In terms of size, the 2009 TSX is larger than its predecessor. The new TSX has a 3.0-inch (76 mm) greater width, a 2.6-inch (66 mm) wider track and a 1.3-inch (33 mm) longer wheelbase than the current TSX; additionally, the length grows by 2.4 inches (61 mm).

2009-acura-tsx_3

2009 Acura TSX

The 2009 TSX comes standard with luxury features like leather seat upholstery, dual-zone climate control, power driver’s seat with memory, sunroof, Xenon headlights, and adds a USB port music interface.[13] The TSX has an optional technology package, which includes a navigation system real-time traffic and weather, and a 10-speaker premium sound system with DVD-audio capabilities. Also making its debut on the new TSX is Honda’s Advanced Compatibility Engineering body structure, which is designed to reduce accident impact on passengers. The TSX was released on July 16, 2008.

2009-acura-tsx_2

2009 Acura TSX

In the IIHS crash tests the 2nd generation TSX received Good overall marks in both front and side impact crash tests and the Good score in all 14 measured categories.[14][15] The IIHS gave the TSX its “Best Pick” accolade.

2009-acura-tsx_1

2009 Acura TSX

At the 2009 Chicago Auto Show, Acura debuted a 3.5L V6 model.[16]

2009-acura-tsx_5

2009 Acura TSX

How to disable seatbelt alarm on Acura Integra 1993?

Filed under: Acura — Tags: — admin @ 9:35 am

2009-acura-tsx2

2009_acura_tl

How to disable seatbelt alarm on Acura Integra 1993?

My car has a passive restrain system with automatic shoulder belts. The problem is that the motor that moves the belt on the passanger side got stuck. So the reminder light stays on and the chime is sounding ALL THE TIME while driving. This is very annoying although I’m getting used to it. I guess I just need to replace the motor but how do I disable the chime in the meantime? Thank you in advance for your answers.

Additional Details I tried pulling the fuses one by one and none of the disabled the chime. And yes, I always make sure my passanger wears at least the lab belt which works fine. The shoulder belt got stuck open, so I removed the belt so it won’t be evident that the shoulder belt is not being worn. Trust me, I’ll fix it but the chime is driving me nuts.

Best Answer – Chosen by Asker

It’s stuck down? Be careful with that. Make sure you wear your lap belt when the shoulder belt is on. People were breaking their necks and/or getting decapitated when they didn’t put on their lap belt. But anyhow, good luck getting someone to tell you how to disable that. Mechanics can get in trouble for telling someone how to disable a safety feature. I know it’s dumb given the situation, but that’s how it is.

It won’t be in the owner’s manual. Since it’s a safety feature, they don’t want you to know how to disable it.

Should I fix dent in trunk of Acura 2003 CL-S and how much should I expect to pay?

Filed under: Acura — Tags: — admin @ 9:32 am

acura-2003-cl-s1

Acura 2003 CL-S

Should I fix dent in trunk of Acura 2003 CL-S and how much should I expect to pay?

I have a dent in the trunk of my 2003 Acura CL-S from backing into a mailbox. I’ll [probably be selling the car in about a year. I got one estimate so far to fix the dent for about $1000. I plan to get a few more estimates. Any thoughts on whether it’s worth it to get the dent fixed and whether $1000 is reasonable?

Best Answer – Chosen by Voters

No…1000 is too much….700 would be better

I have a 96 Acura Integra GS-R, how much would it cost to replace the starter?

Filed under: Acura — Tags: — admin @ 9:29 am

2009-acura-rdx

2009-acura-rdx

I have a 96 Acura Integra GS-R, how much would it cost to replace the starter?

I have had alot of trouble starting my car lately and sometimes i can’t get it to turn off all the way, even with the key completley out. When I try to start it, it makes a click sound but no engine starting. I’m pretty sure its the starter that needs to be replaced. So how much would it cost to get that replaced?

Best Answer – Chosen by Asker

a dealer couldnt evne charge 500

I need to fix my cv joint on my acura how do i do that is there a place to look how for free?

Filed under: Acura — Tags: — admin @ 9:24 am

2009-acura-tl1

2009 acura tl

I need to fix my cv joint on my acura how do i do that is there a place to look how for free?

Best Answer – Chosen by Voters

Your best bet is to get a service manual for your vehicle at an auto parts store. This will give you step-by-step instructions on how to do the job properly, and if any special tools are required. I don’t believe you have to remove the engine, the drive-shaft should come out as a unit. The two critical points to doing this job is A) Thoroughly disassemble the C/V joint and CLEAN IT WELL!!, if you don’t, you’ll just be putting dirt and moisture back into the joint, and it will fail sooner. If you find any rust or pitting or severe wear in the joint components, it’s junk. You’ll need a new joint. B) Torque the axle nut to specifications! Otherwise, you may have premature wheel bearing failure! HTH!! Good Luck!!

Source(s):

ASE Master Technician

I asked about repair cost for a transmission to a 96 acura rl how does the transmission end up jolting?

Filed under: Acura — Tags: — admin @ 9:15 am

2009-acura-tsx3

2009 acura tsx

I asked about repair cost for a transmission to a 96 acura rl how does the transmission end up jolting?

How does that happen to a car what has to happen is it because just over time transmission does that? What could cause the motor mounts or transmission to make the car jolt or jump when I put the gear into revearse

Best Answer – Chosen by Asker

first what type of transmission if it is a manual then it just does that from tim to time but if its an auto matic then something is not right with your tourque converter its kind of like a clutch in manuals best advice is take it in and get the converter checked out

I busted out the right passenger door of my wife's 00' Acura TL. How much will it cost to replace?

Filed under: Acura — Tags: — admin @ 9:12 am

acura-mdx-2009

acura mdx 2009

Best Answer – Chosen by Asker

A used door will be a few hundren dollars. Then it has to be installed. Then you hap to ge it Painted to match the car. I a used one cannot be founded. The a new door. Plug all parts damage on the old. It could run a 1 to 2,ooo. To get answer you need. Take it around to several body shops and get it in writting. Which will hold good for 30 days. I would not take low one or the highest one. Take the one in the middle. Have them noticfy you if it will cost more. Cause something less has to be replace. After market parts will cost less if you can get them.

Source(s):

General knowledge, a exmechanic and exbody repairment.

Acura Integra 1991 – How hard is to change the driver side wheel bearing?

Filed under: Acura — Tags: — admin @ 9:09 am

2009-acura1

2009 acura

Acura Integra 1991 – How hard is to change the driver side wheel bearing? How do I get the hub off? Does the nut have left hand threads or standard. Help.

Best Answer – Chosen by Voters

Get you a Hanes Manual, they tell you everything you need to know. It isn’t that hard of a job, but you will need to know the proper steps to follow.

I do know on my Scion TC that the “Hub nut” has been dented into a slot on the spindle.(A groove down the threads on the spindle, to lock the nut in place) If you don’t bend that dent back out with a punch you will ruin the threads on your spindle, resulting in having to buy another CV joint. Watch out for that one…

Acura Integra, how do I reset the alarm?

Filed under: Acura — Tags: — admin @ 8:53 am

2009_acura_zdx

2009 acura zdx

Acura Integra, how do I reset the alarm?

I tried to jump start my wife’s car and found my battery connector cable loose and it came off. When I put it back, it armed the security alarm and makes noise. I can’t even start my car. I had to remove the battery connection to stop the alarm. Is there any way to reset the alarm? It is a third-party alarm and is 11 years back. I don;t have the remote. Also, somebody tried to break into my car just 4 days back and damaged the driver side lock. I cannot use that to reset the alarm either.

What do you suggest I do?

Best Answer – Chosen by Asker

i own a repair shop,,and you may have to completely disable this alarm system on the vehicle,,without a remote its almost impossible to re-set it,,some of the older ones you could do from the drivers side door lock on it,but yours is damaged,,so you may wind up having to get a newer updated alarm system for it,,and it sounds like you might need it, id check and see,,because the alarm systems being built now are a lot better than the older ones were,,it might be worth the investment to get a new one,,good luck i hope this help,s

Source(s):

been a certified mechanic for 36 yrs.

92 acura legend. How much do i put of the engine restore treatment?

Filed under: Acura — Tags: — admin @ 8:50 am

2009-acura-tsx4

2009 acura tsx

92 acura legend. How much do i put of the engine restore treatment?

hey im back again. i have a 92 legend which handles beautifuly idles fine runs shift everything fine. the only problem is that i have a slap tap. mechanics told me it a sticky valve so alot of people are telling me change oil i just did that like a week ago and tap is still there. So now I have engine restore im curiouse would this fix problem? How much do i put? and can i add it now since i olready had a oil change?, please help…

Best Answer – Chosen by Voters

. I don’t understand the ’solution’ you’ve been offered.

IF the valves are ’sticky’, that means they have some varnish or gum-residue stuff from burning the gas. In a tight engine, NO oil gets on the valve, except the stem area. Otherwise your engine burns Oil.

IF the tappetts or lifters are sticky, ya, clean oil [with a can of 'restore'] might help. BUT that sticky varnish is VERY tough, especially of a 15-yr old car. The ONLY proper way to clean it is to tear the engine apart. $800+.

Until you do that, just keep pumping in cans of valve AND tappett cleaner in the gas tank and oil pan. Read the instructions ON the cans.

Source(s):

<< cleaner

Older Posts »

Powered by WordPress